Quick and Easy

How to Install Your Hooks

Pre-assembled with an allen wrench. No drilling needed.

Watch the Install Video

Watch our quick install video, under 20 seconds.

Quick Install Guide

  1. Step 1:

    Push the Clamps On

    Push the open ends of the clamps onto the post.

  2. Step 2:

    Tighten the Bolts

    Using the provided allen wrench, tighten the bolts, alternating upper and lower.

  3. Step 3:

    Check the Fit

    Ensure that both clamps are still touching the face of the post on the top and the bottom.

Hang up your stuff and Enjoy!

Step by Step Instructions

Follow these steps for a quick, drill-free installation.

  1. Step 1:

    Unpack Your Item

    Unpack the pre-assembled item and locate the provided allen wrench.

  2. Step 2:

    Position the Clamps

    Place the open ends of the clamps either into the grooves of the post for the Groove Clamp or over the edges of the post for the Outside Clamp.

  3. Step 3:

    Hold the Clamps in Place

    Using your thumb and index finger of your left hand gently push the outside of the clamps against the post.

  4. Step 4:

    Snug the Upper Bolt

    Insert the long leg of the allen wrench into the upper bolt and tighten the upper bolt loosely.

  5. Step 5:

    Snug the Lower Bolt

    Repeat for the lower bolt, making sure the clamp is still pushed against the post.

  6. Step 6:

    Tighten the Upper and Lower Bolts

    Re-insert the long leg of the allen wrench into the upper bolt and tighten it further. Repeat for the lower bolt.

  7. Step 7:

    Check Clamp Contact

    Ensure that both clamps are still touching the face of the post on the top and bottom.

  8. Step 8:

    Firmly Tighten the Upper and Lower Bolts

    Insert the short end of the allen wrench into the upper bolt and tighten it firmly. Repeat for the lower bolt.

  9. Step 9:

    Check Contact Again

    Ensure that both clamps are still touching the face of the post on the top and bottom again.

  10. Step 10:

    Top Clamp First

    If a design has more than one clamp, tighten the top clamp first as above, then repeat for the bottom clamp.

  11. Step 11:

    Test the Install

    Check for secure installation with your hand.

Lost Your L-Wrench?

  • These can be found at most hardware stores. They are described as a 1/8 inch Hex L-Wrench, Short Arm.

  • If a design has more than one clamp, tighten the top clamp first, then repeat for the bottom clamp.

Shop Hooks, Hangers and Mini Tables